Camera Resolution & Frame Rate Tester

Camera Resolution & Frame Rate Tester

Request a resolution/FPS preset and see exactly what your camera actually negotiates, plus a live measured frame rate. Nothing is recorded or uploaded.

Click "Start Camera" to allow access and see your live preview below.

Your camera preview will appear here once you start the test.

-- FPS measured
Requested
Width--
Height--
Frame Rate--
Actual (negotiated)
Width--
Height--
Frame Rate--
Reported Camera Capabilities
Capabilities not available for this camera/browser.
Nothing is recorded, saved, or uploaded. This tool only shows a live local preview using your browser's camera APIs — your video never leaves your device.

What Is a Camera Resolution & Frame Rate Tester?

This tool lets you request a specific resolution and frame rate from your webcam - a 480p/720p/1080p/4K preset at 30 or 60fps - and then shows you exactly what your camera, driver, and browser actually agreed to deliver, side by side with what you asked for. It also runs a live, genuinely measured frame counter on the incoming video stream, rather than just trusting whatever number the camera reports about itself.

This is different from a simple webcam preview: cameras and browsers frequently can't (or won't) deliver the exact settings requested, silently substituting the closest supported mode instead. This tool exists specifically to make that gap visible.

Common Ways to Use This Tool

Verify Real Streaming QualityConfirm your webcam is actually delivering 1080p/60fps before going live, not just claiming to.
Inspect Camera CapabilitiesSee the full range of resolutions and frame rates your camera reports supporting.
Diagnose Choppy VideoWatch the live measured FPS counter to see if a call or stream is actually dropping frames.
Web DevelopmentDevelopers can confirm exactly how applyConstraints() and getSettings() behave on a real device.

Frequently Asked Questions

Why is my browser asking for camera permission?

Browsers require you to explicitly grant camera access to any site before it can use your webcam, as a privacy protection. This permission is requested directly by your browser and never touches a server - this tool only receives the live video stream your browser hands it after you approve.

Why doesn't my camera give me the exact resolution or FPS I requested?

Requested settings passed to applyConstraints() are treated as a preference, not a guarantee. Your camera hardware, its driver, USB bandwidth, or the browser itself can all silently substitute the closest supported mode instead of your exact request - this tool shows both the requested and actual negotiated settings side by side specifically to make that visible.

How is the frame rate measured?

This tool counts actual rendered video frames using the browser's requestVideoFrameCallback API where it's supported (Chrome/Edge), which is the most accurate way to count frames the browser has decoded and painted. On browsers without that API, it falls back to sampling frame advances with requestAnimationFrame instead, which is slightly less precise but still a genuine measurement, not an estimate copied from the camera's reported settings.

Is this different from the Webcam & Microphone Tester?

Yes. The Webcam & Microphone Tester is a simple live preview and mic level check. This tool is specifically about resolution and frame rate - it lets you request specific presets, inspect your camera's reported capabilities, and compare requested versus actual negotiated settings with a live measured FPS counter.

Does this tool record or upload my camera video?

No. The video stream is only shown as a live local preview to measure resolution and frame rate - nothing is recorded, saved, or sent anywhere. Closing the page or clicking Stop immediately releases the camera.